Publicidad
EN
Use
EN
First use
Cleaning the appliance
• Before using the appliance for the first time, clean the inside with warm soapy water and a well wrung
damp cloth.
• Refer to the Care and Maintenance section at the end of this manual for further information.
Locating the appliance
• This appliance is for freestanding use only and should be sited between, or at the end of, a run of kitchen
cabinets. Do not build it into a kitchen cabinet.
• Once the appliance is installed and level in its final location, allow at least thirty minutes before switching
on the mains power. This is to allow the refrigerant to settle before use.
Switching on the appliance
• Turn on the mains power and the compressor will start to work.
Control elements
LED light switch
Thermostat dial
5059340158037_MNL_IN_V04.indb 17
5059340158037_MNL_IN_V04.indb 17
• Set to "I" for on and "O" for off.
• Set the thermostat to 1 for the highest temperature, and 7 for the
lowest temperature.
• Set the thermostat to 0 to turn off the appliance.
17
1/11/22 3:32 PM
1/11/22 3:32 PM
Publicidad
