Descargar Imprimir esta página

VITO PRO POWER VISCME305 Manual De Instrucciones página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

Technical Assistance
Your sliding miter should only be serviced by the manufacturer's
internal service personnel, or other qualified personnel,
replacing any necessary parts with original parts.
ASSEMBLY INSTRUCTIONS
Rear support bar
1. Insert the rear support bar into the holes;
2. Tighten the screws.
Clamping the sliding miter saw to a workbench
1. Place the miter saw on a firm, level workbench;
2. Secure the base by tightening the screws, washers and nuts
in the mounting holes.
Side support bars
1. Insert the right (10) and left (16) support bars into the holes;
2. Tighten the screws.
Installing the clamp
1. Insert the support pin into the hole and tighten the screw;
2. Place the clamp (9) on the support pin and tighten the screw.
The clamp can be installed at both ends of the fence (1).
Dust and shavings collection bag
1. Press the holding spring and place the collection bag (2) on
the dust and shavings duct.
2. Release the spring and check that the collection bag is
correctly placed.
Empty the dust bag frequently to prevent the duct from
being clogged.
You can use a vacuum cleaner to collect all dust and
chips. For this, you must use a hose with a diameter of
35mm.
32
Changing the blade
1. Raise the cutting head to an upright position. Pull out the
head lock-down pin (22);
2. Press the blade guard locking lever (18);
3. Rotate the blade guard (7) upwards and loosen the screw;
4. Press the spindle lock button (20) and rotate the blade until
it locks in place. Continue to press the spindle lock button
and loosen the locking screw with the supplied key;
5. Remove the flange and the used saw blade (8);
6. Place the new blade on the inner flange and then the outer
flange. Make sure the blade is correctly installed;
7. Tighten the screw to the spindle thread;
8. Press the spindle lock button and rotate the blade until it
locks. Continue to press the spindle lock button and tighten
the flange with the supplied key;
9. Tighten the blade guard fixing screw (7);
10. Test the saw blade rotation, at maximum speed, to ensure
its correct installation.
Always wear protective gloves when handling and
installing saw blades.

Publicidad

loading