Features
Units LEDs: The AMPS, KW and VOLT LEDs are used to illustrate the units of
F
data displayed on the 3-digit display.
Amp LED: When selected, the load is displayed in amps on the 3-digit display.
kW LED: When selected, the load is displayed in kilowatts on the 3-digit display.
Volt LED: When selected, the voltage is displayed on the 3-digit display.
Output Circuit Breakers: Two circuit breakers protect equipment connected to
6
each load bank against overloads. If a breaker trips, the circuit is overloaded and
you need to reduce the load connected to the circuit breaker's load bank. Press
the circuit breaker button to reset and restore power.
Ground Connection: Allows you to connect a user-supplied ground wire between
7
the PDU and any equipment that requires a chassis ground.
Cord Retention Bracket (Optional Installation): When installed on the PDU,
8
cord retention brackets provide secure attachment points for connected
equipment power cords.
Network Management Card (PDUMH30ATNET, PDUMNH30AT2,
9
PDUMH30HVATNET, PDUMNH30HVAT2, PDUMH32HVATNET,
PDUMNH32HVAT2): The WEBCARDLX accessory allows you to operate the PDU
as a managed network device, accessible via SNMP network management
platform, web browser, SSH or telnet. For details, refer to the WEBCARDLX
Owner's Manual included with this product.
NOT SHOWN—C14 Plug-Lock Insert Sleeve (Optional): Use the
included plastic sleeves to secure C13 power cords to C14 inlets. Fit
the sleeve over the end of the cord, making sure the pull-tabs remain
outside the cord and the fit is secure. To unplug equipment properly,
grip both the cord and the insert's tabs at the same time and pull.
NOT SHOWN—C20 Plug-Lock Insert Sleeve (Optional): Use the
included plastic sleeves to secure C19 power cords to C20 inlets. Fit
the sleeve over the end of the cord, making sure the pull-tabs remain
outside the cord and the fit is secure. To unplug equipment properly,
grip both the cord and the insert's tabs at the same time and pull.
14