Tripp-Lite PDUMH30AT Manual Del Propietário página 2

Important Safety Instructions
This manual contains information concerning the proper
installation and use of Tripp Lite's Rackmount Power Strips.
SAVE THESE INSTRUCTIONS.
Do not connect your power strip to an ungrounded outlet. Do not
use it with extension cords or adapters that eliminate its
connection to ground. Your power strip is designed for indoor use
only. Install it away from heat emitting devices such as radiators
and heat registers. Do not install where excessive moisture or
other conductive contaminants are present. Never install
electrical wiring during a lightning storm.
The power requirement of each device connected to an outlet of
your power strip must not exceed the Outlet Power Rating of your
power strip (see Specifications). The total power requirements of
all devices connected to your power strip must not exceed the
Maximum Load Rating of your power strip (see Specifications).
CAUTION Only those who are properly trained or qualified to use
this device should do so. Anyone who is not trained or qualified
should not use this device unless it is under the supervision of
someone who is properly trained or qualified to do so.
Children must be supervised to ensure that they do not use the
device as a toy.
Never use the device if the cord and plug are damaged; if it is not
working properly, or if it has been dropped or damaged, take it to
an authorized service center for inspection and repair.
If the power cord is damaged, it must be replaced by the
manufacturer, its authorized service agent, or by qualified
personnel in order to avoid a danger.
• The PDU provides the convenience of multiple outlets, but DOES NOT provide surge
or line noise protection for connected equipment.
• The PDU is designed for indoor use only, in a controlled environment, away from
excess moisture, temperature extremes, conductive contaminants, dust or direct
sunlight.
• Keep indoor ambient temperature between 32°F and 104°F (0°C and 40°C).
• The PDU must be installed by a qualified technician only.
• Only those who are properly trained or qualified to use this device should do so.
Anyone who is not trained or qualified should not use this device unless it is under
the supervision of someone who is properly trained or qualified to do so.
• Do not attempt to mount the PDU to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards. Be sure to use the
proper overcurrent protection for the installation, in accordance with the plug/
equipment rating.
2