Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATIONS
• Keep children and other persons out of the working area.
• Do not allow children to play with this tool or its packaging.
• Do not use the tool if parts are missing or damaged.
• Use the tool for the intended purpose only.
• Never place the tool on the vehicle battery. There is a risk of a short circuit.
• Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
• Be careful when working on hot engines because of the risk of burn injuries!
• If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage and personal injuries.
• This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
• After repair or before starting the engine, turn a minimum of 2 turns by hand and check the
timing again.
• Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
• Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulley, camshaft or crankshaft. This can damage tools and engine
components. Only use tools that are suitable for this purpose.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information. Dispose
of this product at the end of its working life environmentally.
USE
Use this tool to hold the Crankshaft Pulley Flange still whilst
releasing the pulley flange centre bolt (left hand thread). In order to
gain access to the pulley flange the pulley must first be removed by
removing the 4 outer fixings pulley fixings.
Note: Do not release the pulley flange centre bolt until the cam and
crank timing pins are in place. Do not attempt to loosen or tighten
the pulley centre bolt without holding the flange with the flange tool
or the crankshaft and camshaft tools will be damaged.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
