TechLine MG-20 Manual De Instrucciones página 13

You need to replace the batteries when:
1. Low battery symbol appears on display.
2. The POWER
Note:
Batteries are hazardous waste.
Do not dispose them together with the household garbage.
Applying the arm cuff
1. Plug in the cuff connecting tube into the unit.
2. Unwrap the arm cuff, leaving the "Index" end of the cuff through the D-ring of the cuff.
3. Put your left arm through the cuff loop. The "OK" range indication should be positioned
closer to yourself with the rubber tube pointing in the direction of your arm. Position the
artery mark ( ) over the main artery (on the inside of your arm) in the upper arm.
4. Turn your left palm upward and place the
edge of the arm cuff at approximately 2 to
3 cm above the inner side of the elbow
joint. Tighten the cuff by pulling the "Index"
end of the cuff.
5. If the Index line falls within the OK
range, indicated at the edge of the cuff,
this cuff is suitable for you. If the Index
line falls out of the OK range, you may
need a special cuff for measurement.
button is pushed and nothing appears on display.
Main
Artery
13
Main
Artery