Sears Kenmore ULTRA WASH 665.1715 Manual De Uso Y Cuidado página 17

Sani Rinse
This high temperature option sanitizes
your dishes and glassware in
accordance with National Sanitation
Foundation (NSF)/ANSI Standard 184
for Residential Dishwashers. Certified
residential dishwashers are not intended
for licensed food establishments. The
Sani indicator indicates at the end of the
cycle whether the Sani Rinse option was
successfully completed. If the indicator
does not activate, it is probably due to
the cycle being interrupted.
Pots & Pans
Normal Wash
Increases the main wash
temperature from 105°F
(41°C) to 130°F (54°C) and
the final rinse from 140°F
(60°C) to 156°F (69°C).
55 lO0
0 - 1.8
(0- Z0)
Heated Dry
Turnsthe heat element on after the wash
cycle is completed. Use rinse aid with or
without the Heated Dry option for best
drying results. Plastic items are less likely
to deform when loaded in the top dish
rack.
Available with
any cycle except
Quick Rinse
Turns the heat element on
at the end of the wash
cycle.
32 32
tThe maximum additional water used for any combination of options is 2.6 gal. (10.0 L).
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCI( ON is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold HEATED DRY for 3 seconds. LOCI( ON will light up. If you press any pad while your dishwasher is locked, the light
flashes 3 times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off the Lock
Press and hold HEATED DRY for 3 seconds. The light turns off.
Selecting Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed, you can simply press STARTonce to show which
options you used, then press START again to start the cycle.
2. Select the desired options. Not all options are available for every cycle.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the
dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
e Ds she s
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Press CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME.
17