Start-Up / Quick Reference - Sears Kenmore ULTRA WASH 665.1715 Manual De Uso Y Cuidado

Connecting to Water and Electrical Supply
1. Run water at the faucet until it is hot. Turn off the water.
2. Pull the hoses out of their storage compartment on the back
of the dishwasher.
NOTE: Make sure the hoses are not kinked or twisted.
Kinked hoses reduce washing performance.
.
Pull down on the locking collar while lifting the hose
connector onto the faucet adapter.
B
4.
5.
6.
A. Faucet adapter
B. Locking collar
C. Hose connector
When the connector snaps into place, release the locking
collar.
Turn the hot water on slowly until it is all the way on.
Plug into a grounded 3 prong outlet.
Disconnecting the Dishwasher
1. Turn off the hot water. (This can be done after the last rinse.)
2. Press the red button on the connector to release the water
pressure.
B
C
D
A. Faucet adapter
B. Locking collar
C. Red button
D. Hose connector
3. Lift slightly on the hose connector while pulling down the
locking collar. Pull down on the connector.
4. Empty any remaining water from the connector by turning
the connector upside-down.
5. Unplug the power supply cord and return it to the storage
compartment.
6. Return the hoses to the storage compartment.
START-UP / QUICK REFERENCE
(VARIES BY MODEL)
ULTRAWASH_HE removable filtersprovide
_k _rmance,
Cleaning the filters
periodically helps keep the
dishwasher working at peak
performance. The filters
can be found at the bottom
center of your dishwasher.
See "ULTRA WASH ®HE
FILTRATION SYSTEM" for
information on removing
and maintaining the filters.
IMPORTANT: Do not block detergent
dis_n_r.
Tall items placed in the
lower rack may block the
dispenser door. Cookie
sheets and cutting boards
loaded on the left-hand
side of the dishwasher can
easily block the dispenser. If
detergent is inside of the
dispenser or on the bottom
of the tub after the cycle is
complete, the dispenser
was blocked.