FR
4.3 PREPARATION
Safety equipment and protective clothing : illustration 3.1
Make sure to wear the appropriate close-fitting protective clothing such as protective pants,
gloves and safety shoes. Do secure long hair so that it is above shoulder level.
ES
Use the following safety equipment when operating the product:
- Hearing protection
PT
- Safety glasses
- Face mask (dust protection)
Extension cord : illustration 3.2
Secure the extension cord using the cord retainer located next to the main handle (2). Securing
IT
the extension cord in this manner prevents accidental removal of the electrical cord during
operation.
4.4 FIRST USE
EL
PL
Pay particular attention using the machine for the first time : focus and dedicate all your attention
RU
to this first use. Make the first trial on a free space with no obstacle and no surrounding element
4.5 OPERATION
Switching on/off : illustrations 4.1 and 4.A
KZ
After having the extension cord secured, connect it to a power source. To start the electric
vacuum blower, slide the ON/OFF switch to position [1]. To stop the unit, slide the ON/OFF switch
to position [0].
UA
Blowing leaves : illustrations 4.1 to 4.4
Before operation, make sure that the leaves are dry enough. Blowing wet leaves will not be
efficient. Hold the tube approximately 10 cm above the ground and walk slowly forward using a
RO
sweeping motion from side to side. While working, ensure that the product does not strike hard
objects, as this can cause damage. Use the full blower nozzle extension. When using the blower
don't point it directly at an obstacle (edge, wall...) as it will spread the leaves everywhere.
Gather the leaves into a pile so that they can be easily collected.
EN
Collect leaves : illustrations 4.A to 4.D
Before operation, make sure that the leaves are dry enough. Make sure that there is no pebbles,
sticks or other solid waste in the area. Holding the vacuum firmly, sweep side to side to pick
up dry leaves. The debris will flow into the bag. Items such as small leaves and twigs will be
mulched as they pass through the fan housing. Once the work is done, shut down the product ,
disconnect the power source and empty the collection bag. Check if there is any blockage/jam
in the suction tube and clean it if necessary.
WARNING ! READ THE « SAFETY INSTRUCTION » SECTION AT THE
BEGINNING OF THIS MANUAL INCLUDING ALL TEXT UNDER
SUBHEADING THEREIN BEFORE USING THIS PRODUCT.
- Protective gloves
- First aid kit in case of injury.
180