Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
13 On/off switch
14 Safety lock
15 Electric motor
16 Front handle
17 Bumper
18 Chain catcher (not visible)
19 Saw bar protection sheath
A
20 Bar bolt
A
21 Sprocket
A
22 Tab
A
23 Screw
A
24 Corner
25 Oil level indicator
26 Minimum mark "MIN"
on the oil level indicator
27 Oil passages
28 Keyhole bore
Technical Data
Electrical Chainsaw ............... PKS 1600 B2
Rated input voltage U .. 230-240 V~, 50 Hz
Input power P ............................1600 W
Safety class ......................................
Protection category........................... IPX0
Chain speed v
.........................14.5 m/s
0
Weight
(with blade bar and chain) ..approx. 4.4 kg
(without blade bar, chain,
blade encasing and oil) .. approx. 3.7 kg
Oiltank ...........................approx. 265 ml
Chain ...................... TRILINK CL15052PB
Chain pitch ..................................3/8"
Chain width ........................... 1.28 mm
Teeth of the sprocket chain wheel ......... 6
Chain bar ........................... Parkside 14"
Length of the chain bar ............... 420 mm
Sawing length ........................... 340 mm
Acoustic pressure level
(L
) ................... 82.9 dB (A); K
pA
Sound power level (L
measured ...102.9 dB(A); KWA = 2.37 dB
guaranteed .......................... 105 dB(A)
Vibration (a
) .....1.719 m/s
h
32
Kangxin AP14-52-507P
= 3 dB
pA
)
WA
2
; K= 1.5 m/s
The product meets the requirements of
EN 61000-3-11 and is subject to special
connection conditions. This means that its
use at freely selectable connection points is
not permitted. If the network conditions are
unfavourable, the device may result in tem-
porary voltage fl uctuations. The product is
only intended for use in premises that have
a mains continuous current carrying capa-
city of at least 100 A per phase and are
supplied with a nominal voltage of 230 V
by a grid. As the user, you must ensure – in
consultation with your electricity supply
company if necessary – that the continuous
current carrying capacity of the network at
the connection point to the public mains is
suffi cient for the connection of the product.
Noise and vibration values were determined
according to the standards and stipulations
mentioned in the declaration of conformity.
The stated vibration emission value was
II
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration and noise emissions
may deviate from the specifi ed va-
lues during actual use of the power
tool, depen-ding on how the power
tool is being used and, in particu-
lar, what kind of material is being
worked on.
Safety measures for the protection
of the operator are to be deter-
mined that are based on an esti-
mate of the actual vibration load
under the real operating conditions
(for this, all parts of the operating
2
Publicidad
