Storage Rack is not recommended for outdoor use.
1. Use some type of lubricant to ease the joining of the angle posts and beams.
2. Use a cloth or wood block to protect the surface finish of the product when using a hammer.
3. Rivets must seat at the bottom of the keyhole slot. Hit the flat section of Z beam.
4. Assemble the unit on a sturdy and level surface. Avoid assembly on carpet.
5. Load small stable items on the top shelves, heavier and bulkier items should be stored on the lower shelves.
Note: To facilitate assembly we recommend having two persons assemble the unit. If you do not
understand these directions, or have any doubts about the safety of the installation, please call a
qualified contractor. We can assist you or give you directions, if you have any defective parts please
do not use, improper installation may result on damage or injury.
A
C
Start the End Assembly by joining a Short Z-beam (part
C) into the two bottom keyholes of an Angle Post (part
A). Install the Z-beam in the upright position, as shown
in the illustration. Drive the rivets to the bottom of the
keyhole by hitting the beam near the joint with a rubber
mallet to lock the pieces together.
Repeat last step to the second Angle Post (part A)
creating an End Assembly.
ATTENTION
OPTION #1 STORAGE RACK
Assembly Steps
A
C
Assemble a Long Z-beam (part B) to the other two
bottom keyholes of the End Assembly. Assure all Z-
beams are assembled in the upright position. As shown
in the illustration. Hit the beam near the joint with a
rubber mallet to lock pieces together.
Note: Don't hit too hard so you will not damage or
bend the beams.
Repeat last step to add an additional Long Z-beam, the
other Short Z-beam and two Angle Posts to the End
Assembly to create the Bottom Frame Assembly.
Note: Follow the order 1st through 5th as shown in
the illustration to facilitate the assembly. Hit the
beams near the joints to lock the pieces into place.
Page 3 of 7
4
th
2
nd
B
5
A
th
C
3
1
rd
st
A
A
B
C
B