Whalen Furniture WSZB1848-5BW-2 Manual De Instrucciones página 4

C
Now pick up a Short Z-beam (part C) and join into the
top two keyholes of the other 2 Angle Post (part A) to
create a Top End Assembly. Drive the rivets to the
bottom of the keyhole with a rubber mallet. Make sure
the flat edge of the Z-beam point up.
Repeat last step for the opposite side Top End
Assembly.
Add a Short Z-beam (part C) to mid section at the joint
by inserting the top rivet of the Z-beam into the bottom
keyhole of the Top End Assembly, and the bottom rivet
of the Z-beam into the top keyhole of the Bottom Frame
Assembly. Make sure all Z-beams in the upright position.
Drive the rivets to the bottom of the keyholes by hitting
the beam near the joints to lock pieces together.
Repeat last step to add an additional Short Z-beam
(part C) and two Long Z-beams (part B).
C
A
A
Page 4 of 7
F
Before joining the Top End Assembly to the Bottom
Frame Assembly insert Post Inserts (part F) into the
Angle Posts (part A) on the Bottom Frame Assembly.
Proceed to assemble the Top End Assembly on to the
Post Insert (part F) as shown in the illustration.
Repeat last 2 step for the opposite Top End Assembly.
Proceed to add two additional Long Z-beams (part B) to
top two keyholes of the Angle Posts (part A) as shown in
the illustration. Install the Z-beams in the upright
position. Assure to have the rivets in the keyholes before
hitting the beams near the joints to lock the pieces
together.