Publicidad
Defl ation
For Spa Tub Wall:
Unscrew the cap to reveal the stem, push the stem in
1.
and turn 90 degree right to secure it in the down
position (see drawing 8).
Once the defl ation is completed, push the stem in and
2.
turn 90 degree left to return it to the infl ation position.
Replace the cap back.
3.
For Cover Air Bladder:
Pull valve cap out and squeeze the valve at its base
1.
until defl ated.
Close and recess the valve back.
2.
Spa Control Unit Installation
Connect the spa control unit to the spa tub (see drawing 9). Hand-tighten the connectors securely.
1.
Do not use tools to tighten.
CAUTION: Do not sit, lean, cover or place any objects over the spa control unit.
A
C
A
C
B
B
Attach the fi lter cartridge housing assembly to the inside of the spa tub outlet grid (marked "B") (see
2.
drawing 10). Infl ate the spa tub fi rst before installing fi lter pump fi ttings.
Before fi lling with water ensure the bottom drain valve caps are securely closed on the inside and outside.
3.
Fill the spa tub with freshwater to a level between MIN and MAX marked on the inside of the spa wall. Do
4.
not over fi ll the spa. Never move the spa tub with water inside and/or with the control base attached to the
spa as the spa or control base may be damaged.
WARNING: Never pour water with a temperature higher than 40°C (104°F) into the spa
directly. It is recommended to fi ll the spa tub with lukewarm water for quick heating and
energy saving.
Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
5.
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT: Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
Ensure the spa is plugged into an electrical socket and press the
6.
panel buttons fi rst. Press the
Panel" operation section.
IMPORTANT: The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5.4 m/s).
• The jet function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
S AVE THESE INSTRUCTIONS
(299IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 06/30/2016
SET UP (continued)
9
button on the control panel to activate the heater, see "Spa Control Unit
English
B
button to turn on the control unit
Page 11
299
A
8
10
Publicidad
