Publicidad
Idiomas disponibles
Idiomas disponibles
Use Insert
see images
-
7
12
1. Unlock the buckle of the harnesses by pressing the red
button.
7
!
To ensure the best protection for the child, always use the
small insert when the child's shoulder height is lower than
the headrest bottom.
2. Engage the buckle. Please refer to
3. When the child's shoulders are higher than the headrest
bottom without the support from the small insert, remove
the lower body insert
12
until the child does not fit comfortably.
!
This may vary depending on regions.
Use Top Tether
see images
-
13
18
1. To extend top tether for use, press button on tether adjuster
and pull to lengthen.
15
2. Connect the tether hook securely to the anchorage fitting.
!
Use top tether for installation if vehicle is equipped with a
tether anchorage fitting and vehicle requirements are met
(see vehicle owner's manual).
!
When not in use, top tether must be properly stored. To
make sure the top tether is properly stored away, remove
any slack in strap to avoid the top tether swinging around
when the vehicle is in progress.
17 18
11
.
10
, and use upper body insert only
Use Isosafe System
see images
-
19
1. If required attach the plastic guides onto the vehicle ISOFIX
bars.
19
2. Extend the Isosafe connectors by depressing on the
release button
!
Make sure that both Isosafe
connectors are securely attached to their ISOFIX anchor
points. The colors of the indicators on both Isosafe
connectors should be completely green.
!
Press the Isosafe connectors
base back against the vehicle seat until tight.
Removing the base
1. To remove base from the vehicle press the release button
and pull the base back from the seat.
2. Then press
-1
24
3. For transporting base, press Isosafe connectors button
and move back Isosafe connector so it is folded completely.
25
16
25
whilst pulling on the connector.
20
button
20
23
and pull back on the Isosafe connector.
21
22
and push the
20
-2
24
20
12
Publicidad
