Descargar Imprimir esta página

PPA TRIFLEX CONNECT FULL RANGE DUPLA Technical Manual página 24

Publicidad

Idiomas disponibles

Idiomas disponibles

"LG"
"RAMPA"
Additional functions can be programmed through the PROG programmer
(Programming tool).
5 – CLEAR (ERASE) THE MEMORIZED TRAVEL (PATH)
To clear the memorized travel of the gate, press the 'CMD' button and hold it
pressed until the 'SN' LED gets lit. When the button is released, the memorized
travel is cleared.
Note: The 'PROG' jumper must be open.
6 – RESTORING THE FACTORY SET DEFAULTS
To restore the factory settings, press the 'CMD' button until the 'SN' LED gets
lit; do not release it; hold it pressed until the 'SN' LEd starts flashing. When the
button is released, the memorized travel is cleared, and the factory settings
are restored.
Note: The 'PROG' jumper must be open.
7 – ADDING AN RF TRANSMITTER
In order to add an RF transmitter, press the button on the transmitter and hold
it pressed for at least 2 seconds. After the two seconds have elapsed, press
the 'CMD' button on the control board. Observe that before the transmitter
has been added, the 'SN' LED was quickly flashing; afterwards, it remains lit
(on) during the transmission. A maximum 256 Fixed Code (FC) or Rolling Code
(RC) can be added.
8 – ERASING ALL ADDED RF TRANSMITTERS
In order to erase all added RF transmitters, close the 'PROG' jumper, press and
release the 'TX' button once and then press it again and hold it pressed for
10 seconds; observe that the 'SN' LED flashes every one second. After the ten
seconds have elapsed, the 'SN' LED stops timing; at this moment all added
transmitters will have been erased.
9 – SELECTING THE RF RECEPTION PROTOCOL (FC/RC)
The control board is factory set to receive a Fixed Code from the remote con-
trols; in order to select the reception protocol in Rolling Code mode (RC), just
activate the 'CR/CF' DIP Switch.
24
Courtesy Light time.
Selects the time the 'LG' output remains active after the gate
has closed. It has an interval of 30 seconds, from 0 second up
to 240 seconds.
Close Limit Switch.
Increases or decreases the speed the operator starts
decelerating on closing and opening. It has an 8-level
adjustment.

Publicidad

loading

Productos relacionados para PPA TRIFLEX CONNECT FULL RANGE DUPLA