Publicidad
Idiomas disponibles
Idiomas disponibles
13 – FUNCTIONS ACCESSIBLE THROUGH PROG
Add a remote
control
Pause time
Closing ramp
(deceleration zone)
Opening ramp
(deceleration zone)
Opening speed
Closing speed
Opening ramp
speed
Closing ramp speed
Strength (Force)
applied to the
motor
Strength (Force) in
low speed
Courtesy Light time Countdown (Timer) which automatically turns the
Follow Photocell
Mode
This function is used for both adding remote control
and removing (erasing, deleting) them. In order to
add one, one has to press a button on the remote
control for 2 seconds and them press the '+' button
to add it. Repeat the procedure for the other buttons
to add them to the control unit memory (optional).
In order to remove all remote controls, press both
'-' and '+' buttons simultaneously and keep them
pressed until the message "Memória Vazia!" (Empty
Memory) appears on the display.
Pause time in automatic mode; when a 0-second
time is selected, it enters semi-automatic mode.
Area in which the gate starts decelerating prior to
the closing.
Area in which the gate starts decelerating prior to
the opening.
Frequency applied to the motor in order to open
the gate.
Frequency applied to the motor in order to close
the gate.
Speed applied to the motor on the area near the
open gate.
Speed applied to the motor on the area near the
closed gate.
With this function, it is possible to apply a lower
strength to the operator to meet anti-crush systems'
requirements.
Strength applied to the motor when in low rotation,
deceleration area.
courtesy light off after the gate has closed.
Function used to automatically close the gate after
a vehicle passes through the photocell beam. When
0 second is selected, the function is deactivated.
With a time different from 0, the gate starts closing
after all sensors are clear and all preset times had
been elapsed. In case any sensor is obstructed, the
timing is reset.
27
Publicidad
