Publicidad
Idiomas disponibles
Idiomas disponibles
•
A brand new device should not be running at the highest speed for the first
few days of use to avoid high loads during the run-in period of moving parts.
The engine will reach its maximum power after using min. 5 fuel tanks.
•
The device vibrations may cause the fuel filler cap to loosen or to twist off
when incorrectly locked and lead to leakage. To avoid this situation, make
sure the filler cap is properly tightened before each use.
•
Use the full extension of the blower nozzle so that the air stream is as close
as possible.
•
If you notice a decrease in the power of the machine, verify the condition of
the air filter. If necessary, clean or replace it with a new one.
•
It is recommended to replace the spark plug ca. every 100 hours of use.
3.4.
a)
Before cleaning, adjustment, replacement of accessories, and when the device
is not in use, turn off the engine and disconnect the spark plug wire and wait
until the device has cooled completely.
Wait until the rotating parts stop.
•
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the device is used
again.
d)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the device with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the
housing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the device checking technical fitness and any
damages.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the
device is made.
k)
Do not clean the device with acidic substances, medical products, diluent,
fuel, oil or other chemicals as this may cause damage to the device.
•
CAUTION: Disassembly, replacement and gap adjustment must be done when the
engine is cold (cold plug)!
Cleaning and maintenance
Spark plug
Publicidad
