hillvert HT-LOGAN-1250B Manual De Instrucciones página 39

- To replace a spark plug, first, clean the area of debris to prevent it from getting it
into the socket, then remove the spark plug boot and clean the socket.
- Use the wrench provided to unscrew the spark plug.
- Check the spark plug for wear or damage. If necessary, replace with a new one
(Note: always replace with the same type of spark plug). If the spark plug is to be
reused, clean it with a wire brush.
- Check the spark plug gap, adjust if necessary. The gap between the electrodes
should be: 0.6-0.7mm.
Caution: Incorrectly installed spark plug or a spark plug of a different type than the
one originally installed in the device can cause engine damage.
Air filter
•
CAUTION!: Do not start the engine without the air filter in place.