CYBEX ONYX Manual Del Usuario página 17

Do not carry additional children, do not hang shopping bags from the
handlebars or carry shopping bags on the stroller except in the stroller's
basket. Maximum load 2 kg. Otherwise the stroller is likely to become unstable.
Overloading can also damage the vehicle. Maximum load canopy bag 0,5 kg.
–
Damages caused by the use of accessories not approved by CYBEX, such as
rain covers, buggy boards, bag hooks, etc. will not be covered by the terms
of our warranty.
–
It may be unsafe to use replacement parts other than those approved by
CYBEX.
–
Before using the stroller, always check whether the accessories are well
secured.
–
Ensure that the stroller is always in the brake position when you put and
remove your child into the seat.
–
Never lift the stroller with the child inside; never ascend or descend stairs or
escalators with the child inside or when traveling on other forms of transport.
–
When opening and closing the stroller, do not use force, as incorrect folding
can damage or break the stroller. Check the instruction manual if necessary.
–
Drive carefully over curbs and gravel roads. The vehicle will be damaged by
repeated impact.
–
Make sure your child does not use the footrest to stand on.
–
Do not expose the stroller to any artificial heat or direct sunlight.
II. INSTRUCTIONS FOR MAINTENANCE
–
The user is responsible for the regular maintenance of the stroller. All
connecting parts and rivets have to be tightened and secured properly. It is
particularly important to ensure that the locking mechanism and swiveling
mechanism are treated regularly with Teflon spray (dry lubricant). It is
important that brakes, wheels and tyres are not impaired during use. Inspect
them regularly and repair or replace if necessary. STOP using any product that
does not appear structurally sound.
–
Do not make any modifications to the product. If you have any complaints or
problems, please contact your supplier or importer.
–
A service should be scheduled every 12 months.
–
You can also treat the other moving parts with Teflon spray (dry lubricant).
After spraying on the Teflon, wipe the product with a soft cloth.
–
Use only original CYBEX replacement parts. It may be unsafe to use substitutes.
–
The frame tubes covered by the locking mechanism and turning mechanism
should also be regularly cleaned and sprayed. This will ensure that you enjoy
your stroller without any problems.
CLEANING
–
Do not use abrasives to clean the frame! Use a damp cloth and a mild
detergent and dry thoroughly.
–
Should the stroller be exposed to salt water, please rinse it down with fresh
(tap) water as soon as possible afterwards. The seatcover and the canopy
can be washed by hand with mild detergent (not warmer than 30°C).
–
The seatcover is maschine washable (See care label for details). Do not use
the tumble drier. Dry thoroughly before reuse.
–
All CYBEX fabrics have been tested, but when the stroller is very wet, the water
may permeate the lining through the bottom edges and seams and leave
water stains on the upholstery. We advise you to use a rain cover to avoid
this. Also please do not fold or store the product while wet. If the stroller is wet,
allow to dry with the hood extended. Never store in a damp environment as
this can cause mildew to form.
Note! Please wash the cover separately before you use it the first time. Do not
tumble dry and do not expose to direct sunlight! Do not iron!
THIS PRODUCT WAS APPROVED ACCORDING TO THE
EN1888:2012 STANDARD.
SERVICE
In general the Cybex pushchairs will run smooth without any problems. A dry and/
or dusty environment can have a negative effect on the wheel systems. To avoid
this it is very important that the wheel systems will be regularly checked, cleaned
and lubricated. This will ensure a smooth operation of the stroller in daily use.
Please follow the instruction below to maintain the wheel systems (wheel axles &
suspension system).
II.-I Check of wheel systems
a) Wheel system must be cleaned before applying the lubricant.
b) Wheel system must not be broken or damaged.
c) For eliminate squeaking on you CYBEX buggy take only WD 40 and follow
the mentioned pictures below. Do not use any other kind of lubricant! Insert
always a cloth or a carton in order to leave no oil stains. Please pay special
attention to not apply the lubricant on any other part of the stroller (fabrics,
tubes, etc.).
II.-II Applying of the lubricant
a) Rear Wheel - Spray from the rear side of the buggy in the space between the
rim and the housing on both sides. Let the lubricant get into the system for
approx. 10 seconds, and then turn the wheels.
9