Kicker KXMA800.8 Manual Del Propietário página 2

MODEL:
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER
IN A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO
SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS
DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4
INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT
LEAST 1 INCH (2.5CM) CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY
SURFACE.
PERFORMANCE
Model:
RMS Power
@ 14.4V, 4Ω stereo, ≤ 1% THD+N
@ 14.4V, 2Ω stereo, ≤ 1% THD+N
@ 14.4V, 4Ω bridged mono, ≤ 1% THD+N
Length [in, cm]
Specifi cations common to all models:
Height [in, cm]
Width [in, cm]
Frequency Response [Hz]
Signal-to-Noise Ratio [dB]
1W Signal-to-Noise Ratio [dB]
Input Sensitivity
Selectable Electronic Crossover
KickEQ™ Bass Boost
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no
items behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm)
of open ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger
compartment. Drill four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the
amplifi er.
Wiring: The KXMA amplifi er's RCA inputs will receive either high or low level signals from your car stereo's
source unit. A high-level signal can be run from the source unit's speaker outputs to the stereo RCA
input on the end panel of the amplifi er using the KICKER KISL as shown. Alternatively, the signal can be
delivered to the amplifi er using the low-level RCA outputs on the source unit. Keep the audio signal cable
away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a
90 degree angle.
2
2021 KXMA 8-CH Amp Rev C.indd 2 2021 KXMA 8-CH Amp Rev C.indd 2
KXMA.8 SERIES AMPLIFIERS
OWNER'S MANUAL
KXMA800.8
KXMA800.8
50 x 8
100 x 8
200 x 4
14-3/4, 37.4
2-1/8, 5.5
8-5/16, 21
10Hz–20kHz
95dB
-75dB
Low Level: 125mV–5V
High Level: 250mV–10V
AMP1 and AMP2: Off; Variable HP, 10-500Hz; Variable LP
10–500Hz; HP and LP 100–5000Hz with 10X Switch; Slope: 24dB/
octave
AMP3 and AMP4: Off; Variable HP, 10-500Hz; Variable LP
40–500Hz; LP 400Hz–5000Hz with 10X Switch (bandpass capable);
Slope: 24dB/octave
0–6dB @ 40Hz
10/6/2020 7:10:57 AM 10/6/2020 7:10:57 AM