Publicidad
Idiomas disponibles
Idiomas disponibles
Control panel
Display
Button
Power on
Power off
RESET
Water temperature
Use of the appliance
Initial ignition must be performed by the authorised Technical
Support Service that must check
Appliance start-up
Following the necessary checks, proceed with the following operations:
Electrically power the water heater
Open the gas valve installed upstream of the water heater
Open the water tap at the bottom of the water heater
Press the power button
The display shows:
1. Software review
2. The type of gas for which the water heater was designed:
(G20) -
(G30) -
3.
Low Emission product
4. Model:
(C-Meister 11 P37 Eco) -
(not available) -
With the first ignition procedure completed, the display shows the
symbols
(Fig. 13)
Press the button
to power the water heater, the display shows the
set point temperature, the symbol
progress) and the symbol
(in case of burner ON).
Service toolgate
MENU
EXT
MEM
Eco
control knob
(G31)
(C-Meister 14 P37 Eco)
(not available)
(in case hot water request in
3
2
1
1.
Presence of fault
2.
Presence of flame (flame symbol)
Flame fault (symbol crossed out)
3.
Hot water request in progress
4.
Set point temperature
Faults / Alarms
5.
Not used
6.
Solar system connection
Water temperature adjustment
The water temperature can be set between 37 and 60°C.
Turn the ignition button clockwise to increase the temperature
and counter-clockwise to decrease it. The symbol
the display shows the new temperature set for 5 seconds.
Switching off the appliance
Hold down for about 5 seconds the water heater power off button
As soon as the symbols
The appliance will be in the OFF state and the display shows the
symbols
(fig. 13).
From this point forward the appliance remains inactive.
In case of power off for lengthy periods, disconnect the omni-po-
lar switch outside the water heater and close the gas valve up-
stream of the water heater
In the event that there is a possibility that the temperature in
the room could drop below 0°C, empty the water heater of the
water by closing the cold water inlet valve and opening the hot
water tap below the water supply network of the room.
To power the appliance, press for about 5 seconds the power button
9
Display
4
MENU
EXT
MEM
start flashing, release the button
5
6
flashes and
.
Publicidad
