Publicidad
Idiomas disponibles
Idiomas disponibles
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Connect the dust extractor hose to the connection
for dust extractor. Refer to
3 for information about where the connection for dust
extractor is on your product.
To connect the product to a power
source
1. Connect the power plug of the product to an
applicable extension cable.
2. Connect the extension cable to a mains outlet.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to an
applicable power source.
To start the product
1. Start the dust extractor.
2. Put the cord of the operator presence control around
your right wrist.
12
Product overview on page
When the product is
3. Push the drive system pedals to engage the drive
system.
4. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
5. Set the main switch on the electrical enclosure in the
ON position.
6. Set the joysticks in neutral position.
7. Push the ON button for the drive motor (A). The light
(B) comes on when the drive motor has power.
A
B
E
8. Push the ON button for the drum motor (C). The light
(D) comes on when the drum motor has power.
Note:
The drum motor cannot start if the drive
system is not on.
9. Wait 10–15 seconds until the color of the display (E)
changes from red to white.
C
D
1838 - 003 - 09.02.2023
Publicidad
