Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not use a product if it is damaged or does not
operate correctly.
•
Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
Emergency stop button
The emergency stop button is used to quickly stop the
motor.
To do a check of the emergency stop button
Control panel overview on page 4 for
Refer to
information about where the emergency stop button is
on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 12 .
3. Push the emergency stop button.
4. Make sure that the motor stops.
5. Turn the emergency stop button clockwise to
disengage.
Operator Presence Control (OPC)
When the OPC is engaged, the motor stops. Refer to
do a check of the Operator Presence Control (OPC) on
page 9 .
To do a check of the Operator Presence Control (OPC)
1. Start the product. Refer to
page 12 .
2. Pull out the OPC key. If the motor does not stop in
3 seconds, speak to an approved Husqvarna service
agent.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
4. Make sure that only approved persons are in the
work area.
1838 - 003 - 09.02.2023
To start the product on
To start the product on
Operation
Before you operate the
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Before you do the maintenance, stop the motor,
push the emergency stop button, pull out the
operator presence control and disconnect the power
plug.
•
Do the maintenance of the product on stable level
ground.
•
Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
•
Replace damaged, worn or broken parts.
To
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
•
Let an approved service agent do servicing on the
product regularly.
5. Do daily maintenance. Refer to
schedule on page 14 .
6. Make sure that the product is assembled correctly
and is not damaged.
7. Put the product on the work area. Make sure that the
surface is level. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
8. Make sure that the height of the front wheels is set
correctly for the operation. Refer to
height of the front wheels on page 11 .
9. Make sure that the tools do not hit the ground.
a) Set the lift lever in the up position.
b) Turn the depth adjustment wheel clockwise.
10. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 11 .
Read the warning
Maintenance
Transportation on page 18 .
To adjust the
To
9
Publicidad
