MSW Motor Technics MSW-TW-ET20000 Manual De Instrucciones página 28

The ambient temperature must not exceed 40°C and ambient humidity should not
exceed 85%. Place the unit in a way that ensures good air circulation. Maintain a
minimum distance of 3 m from each side of the unit. Keep the unit away from any
hot surfaces and flammable materials as well as direct sunlight. Always operate the
unit on a level, stable, clean, fireproof and dry surface and out of the reach of
children and persons of impaired mental, sensory and intellectual functions. Place
the unit in such a way that the mains plug can be reached at any time. Ensure that
the power supply to the unit corresponds to that specified on the identification
plate! Refuel only with the unit turned off.
ASSEMBLY OF THE UNIT
Insert the axle (H) of the wheels into the holes at the ends of the lower
•
frame (B), then place the wheels (F) on its ends.
• Then, on the ends of the axle (H) protruding through the holes in the
wheels, put flat washers (G) and secure them with self-locking nuts (E) at
its ends.
• Through the holes in the axles from the inside of the wheels, insert the
safety clips and bend their ends to prevent them from falling out.
Place the heating unit with the fuel tank on the so-prepared lower frame
•
(B), making sure that the holes at the ends of the tank are aligned with the
holes in the lower frame.
Attach the transport handle (A) from above, also making sure that the holes
•
in it are aligned with the holes at the ends of the tank and the lower frame
(B).