Publicidad
Idiomas disponibles
Idiomas disponibles
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
•
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Make sure that no water enters through the ventilation openings in the casing.
f)
Clean the ventilation openings with a brush and compressed air.
g)
Perform regular inspections of the unit checking technical fitness and any
damages.
h)
Use a soft cloth for cleaning.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
j)
Do not store fuel in an unused unit for more than 2 months.
k)
In the case of regular use (8-10 hours a day), clean the unit:
•
Once a month - the ignition electrodes and the combustion chamber.
Every six months - the fuel tank.
•
3.4.1 Draining the fuel tank
IMPORTANT: the device has a built-in protection in the event
of excessive flame, which, for safety reasons, will cut off the
fuel supply and turn off the fan after 90 seconds. In the event
of a power failure, the unit will stop working immediately.
When the power returns, the device will only signal this fact
by lighting up the power supply control, but it will not start
up automatically - for safety reasons, you should restart it
manually.
Publicidad
