Publicidad
Idiomas disponibles
Idiomas disponibles
LED Reading
E90
Water temperature too low
E94
Water temperature too high
E95
E96
Dry-fi re Protection
E97
Water temperature sensor broken • Contact Intex Service Center.
E99
After 72 hours of continuous
heating operation, the pump will
hibernate automatically. The rapid
END
heating and water fi ltration
functions are disabled.
S AVE THESE INSTRUCTIONS
(347PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/11/2019
LED CODE CHART
CAUSE
• Turn off and unplug the control unit.
• Ensure the outlet cover grid is clean and free
from obstructions.
• Clean or replace the cartridge, see
Maintenance and Storage section.
No water fl ow
• Ensure the in/outlet connections on the spa tub
and fi lter pump are not blocked.
• Keep the spa water properly sanitized to
ensure a clean and unclogged fi lter cartridge.
• If problem persists, contact Intex Service
Center.
• If the ambient temperature is below 39°F (4°C),
we recommend not to use the spa.
• Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 41°F (5°C), then press the
heat up the water to the desired temperature.
• If problem persists, contact Intex Service
center.
• Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
• Turn the heater off, then press the fi lter and
bubble buttons to lower the water temperature.
• If problem persists, contact Intex Service
Center.
• Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
System Error
• If problem persists, contact Intex Service
Center.
• Contact Intex Service Center.
• Press the
fi lter pump.
English
SOLUTION
button to
button to re-active the
Page 14
347
PO
Publicidad
