Publicidad
Idiomas disponibles
Idiomas disponibles
•
Humidity is a natural side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation, moisture in the room.
Additional requirements for outdoor installation
•
Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting, and other safety requirements. Contact your local building code enforcement offi ce for further
details.
•
Make sure the surface is level, fl at, smooth and strong enough to support the full weight of the fi lled spa.
•
Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and
damage the spa fl oor.
•
Do not expose the spa to direct sunlight for extended period of time. Provide protection from the
sun such as sunshade, tent, awning or gazebo.
•
It is possible to install and leave the spa outside at a temperature not lower than 39°F (4°C) provided the
water temperature inside the spa is higher than 39°F (4°C) and the water inside the circulation system,
pump, pipe are not frozen. Put a "temp barrier mat" between the spa fl oor and the ground to prevent heat
loss from the bottom of the spa and to provide better heat retention. Do not use the spa if the ambient or
water temperature is 39°F (4°C) or lower.
Setup the spa with at least 2 persons.
Move the entire package to the selected site. Do not drag the spa tub across the ground as this can
1.
cause damage and leakage.
Open the carton carefully as this carton can be used to store the spa during long term storage or when
not in use.
Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or
2.
damaged parts contact the appropriate Intex Service Center listed in the separate "Authorized service
Centers" sheet.
Safety Sign Card Posting
The Safety Sign card included with the manual shall be posted in an area visible to the users of the spa to
alert them of the safety rules and warnings. For replacement of the safety sign card, visit our website at
www.intexcorp.com for additional print copies. Laminate the printed safety sign copy for protection from the
elements.
Spa Control Panel Adjustment
Push the lever down to tilt up the control panel and fl ip up the panel cover (see drawing 1.1).
1.
To stow the control panel back push the button located on the back inward while pushing the control
2.
panel down (see drawing 1.2).
S AVE THESE INSTRUCTIONS
(347PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/11/2019
SET UP (continued)
1
2
347
English
PO
1.1
1.2
Page 8
Publicidad
