Haojue TZ150S 2015 Manual De Uso página 100

BWARNING
After a new brake disc or pad is installed, the
braking distance may be a little longer than the
original value. After the brake discs and brake
pads have realized full break-in following a mileage
of about 300 km, the best braking effect will be
realized. Make sure there is an enough braking
distance when riding before that.
BWARNING
Fail to inspect and maintain the brakes pads or
brake disk, and replace them when recommended
can increase your chance of having an accident.
If you need to replace brake disk or brake pads,
have your Haojue dealer do these works. Inspect
and maintain the brake disk and brake pads as
recommended.
REAR BRAKE (DRUM BRAKE)
Adjustment of rear brake pedal
Free stroke 1 of the rear brake pedal refers to the stroke
between the pedal's free position and the pedal's position
when the pedal is stepped down on to brake the rear
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
wheel.
When adjusting the free stroke 1 of the rear brake pedal,
set the pedal at a comfortable position, adjust the pedal
by rotating the pedal limiting bolt 2 and then rotate the
adjusting nut 3. Turn it clockwise for a smaller free stroke,
or anticlockwise for a larger one. Make the free stroke 1
20–30mm.
NOTE: If follow the steps, the free stoke is not required,
please have it checked by the authorized dealer.
Wear limit of rear brake
There is a wear limit mark on
the rear brake of the motorcycle.
Inspect the wear situation of the
rear brake following the essentials
below.
1. Inspect whether the braking
2. Operate the braking system and inspect and make
TIRES
Periodic checks should be performed for tire pressure
40
https://www.motomanuals.net/
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
system has been properly
adjusted.
sure the mark extending line 1 is in the allowed range
3 (see the figure) marked on the wear limit mark
2, otherwise have the component in the rear brake
replaced by a qualified distribution and maintenance
organization for safety.
(99)
The mark
extending line is in
the allowed range
EN
(99)