GreenWorks GD40BC Manual Del Operario página 8

4. Tighten the screws.
5. Put the guard cap onto the guard.
6. Align the screw holes on the guard cap with the
screw holes on the guard.
7. Tighten the screws.
3.3 ASSEMBLE THE SHAFT
Figure 3.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole
and move the two shafts towards each other.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
3.4 ATTACH THE AUXILIARY HANDLE
Figure 4.
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle and lower clamp on the
shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
3.5 USE THE SHOULDER STRAP
Figure 5
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.6 INSTALL THE BATTERY PACK
Figure 6.
WARNING
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery slot.
2. Push the battery pack into the battery slot until the
battery pack locks into place.
3. When you hear a click, the battery pack is installed.
English
3.7 REMOVE THE BATTERY PACK
Figure 6.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1 START THE MACHINE
Figure 7.
1. Push the on/off button.
2. Push the lock-out button and pull the trigger.
3. Push the speed button to adjust the speed
according to the grass condition.
4.2 STOP THE MACHINE
Figure 7.
1. Release the trigger.
2. Push the on/off button again to turn the machine off.
4.3 OPERATION TIPS
Figure 8.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
4.4 CUTTING TIPS
Figure 9.
5
IMPORTANT
WARNING
WARNING
WARNING
EN