Intended Use; Special Safety Instructions - Rothenberger ROSPI H+E PLUS Instrucciones De Uso

1 Safety Notes
1.1

Intended use

This device may only be used in accordance with the regulations as stated.
Universally deployable for the cleaning of all pipes with a Ø 10 - 75 mm (= Tab. 1) pipe diame-
ter.
Elimination of all obstructions in the drain pipes of sinks, hand wash basins, showers, bath tubs
and toilets.
1.2

Special safety instructions

If a drill is being used, the electrical installation must be checked at the workstation before put-
ting into operation the pipe cleaning device. For this purpose please read the information in the
operating instructions of the drill.
Accident prevention regulation!
Your attention please! If operating a drill, it is imperative that the crank handle is removed!
Never use a drill without an electronic speed control - danger of accidents! Only use the coun-
terclockwise rotation of the drill, when the spiral is secured in the pipe or in the event of its with-
drawal!
Your attention please! Commence cleaning work with low rotational speed and increase if re-
quired.
2 Description
The ROSPI H+E Plus hand pipe cleaners are designed both for manual crank operation as well
as for electrically driven operation by means of using a commercially available drill (not included
in the scope of supplies). The flexible spiral, fitted with an extended operating head, is particular-
ly suitable for using in narrow pipe bends and elbow joints.
Cleaning work in the sanitary area can be carried out without the removal of sink sieves or sani-
tary traps.
The closed, impact-resistant plastic spiral container prevents the accumulation of dirt in the
working area.
Tab. 1: The following versions are available:
Product number .................... 72090 ...................... 72095 ...................... 72005
Spiral end diameter ............... 6,4 mm .................... 8,0 mm ..................... 10,0 mm
Spiral length .......................... 4,5 mm .................... 7,5 mm ..................... 10,0 mm
Recommended
workspace ............................ 10 – 40 mm ............. 20 – 50 mm .............. 20 – 75 mm
3 Overview
1 Crank handle
2 Spiral with extended operating head
3 Spiral clamping chuck / locking screw (ROSPI 6 H+E Plus)
4 Spiral pot
4 Operating
If operating with a drill the crank handle must be removed, the central adapter-retaining pin
(hexagon) should be mounted in the drill (Picture 2 + 3).
Pull the spiral out of the spiral container and insert it into the pipe, which is to be cleaned, until
resistance (obstruction) becomes noticeable.
There must still be approx ca. 20 - 30 cm of spiral between the cleaning device and the pipe
opening. Tighten the spiral chuck!
4
ROSPI 6 H+E Plus
ENGLISH
ROSPI 8 H+E Plus ROSPI 10 H+E Plus
(A)
(B)