Publicidad
Idiomas disponibles
Idiomas disponibles
General safety instructions
•
Keep fingers away from trigger when not
operating this tool and when moving
from one operating position to another.
•
Multiple hazards. Read and understand
the safety instructions before connecting,
disconnecting, loading, operating,
maintaining, changing accessories on,
or working near the tool. Failure to do so
can result in serious bodily injury.
•
Keep all body parts such as hands and
legs. etc. away from firing direction
and ensure fastener cannot penetrate
workpiece into parts of the body.
•
When using the tool, be aware that the
fastener could deflect and cause injury.
•
Hold the tool with a firm grasp and be
prepared to manage recoil.
•
Only technically skilled operators should
use the fastener driving tool.
•
Do not modify the fastener driving
tool. Modifications may reduce the
effectiveness of safety measures and
increase the risks to the operator and/or
bystander
•
Adhere to information for tools intended
to be used on hard surfaces such as steel
and concrete regarding the additional
downforce required to operate the tool
and prevent slipping.
•
Do not discard the safety instructions.
•
Do not use a tool if the tool has been
damaged.
•
Be careful when handling fasteners,
especially when loading and unloading,
as the fasteners have sharp points which
could cause injury.
•
Always check the tool before use for
broken, misconnected or worn parts.
44
•
DO not overreach. Only use in a safe
working place. Keep proper footing and
balance at all times.
•
Keep bystanders away (When working
in an area where there is a likelihood of
through traffic of people). Clearly mark
off your operating area.
•
Never point the tool at yourself or others.
•
Only Wear gloves that provide adequate
feel and Safe control of triggers and any
adjusting devices.
•
Always use the second handle (if
supplied).
•
If stopping work briefly, place the nail
gun on its side so that it cannot be fired
towards people. Make sure it is on a
stable and secure surface.
Projectile hazards
•
The fastener driving tool shall be
disconnected when unloading fasteners,
making adjustments, clearing jams or
changing accessories.
•
During operation be careful that
fasteners penetrate material correctly
and cannot be deflected/ misfired
towards operator and/or any bystanders.
•
During operation, debris from workpiece
and fastening/collation system may be
discharged.
•
Always wear impact-resistant eye
protection with side shields during
operation of the tool.
•
The risks to others shall be assessed by
the operator.
•
Be careful with tools without
workpiece contact as they can be fired
unintentionally and injure operator and/
or bystander.
•
Ensure tool is always safely engaged on
the workpiece and cannot slip.
Publicidad
