cecotec CONGA WINDROID 880 SPRAYWATER CONNECTED Manual De Instrucciones página 46

ENGLISH
optimum result.
- If you use the machine in sunny days or with low humidity, the dry mode will get better
results.
4. CLEANING AND MAINTENANCE
- Use a soft, damp cloth to clean the product's outside surface.
- The cleaning cloths are washable and reusable.
- Do not immerse the product in water or put it under running water.
- Do not expose the robot to direct sunlight or high temperatures.
5. TROUBLESHOOTING
The robot slips and cannot detect the upper
window frame in Auto up and down mode.
The robot does not finish cleaning the whole
window and stops in the middle.
The robot does not move smoothly or moves
irregularly.
After cleaning, the robot leaves a mark on the
glass surface.
46
Step 2. Spraying mode
- Choose the spraying mode. Select the automatic
or manual cleaning mode, according to the desired
spraying frecuency or the areas to be cleaned.
- Remember that if the device cloths are too wet,
you may not get the desired cleaning result. It is
recommended to slightly moisten them.
Problem Cause
Press stop and select the left and
down cleaning mode
cleaning.
Press left and right buttons to continue
cleaning.
The cleaning cloth is too dirty. Clean it or
replace it.
Remove stickers or films on the window.
The screw on the cleaning wheel is loose,
tighten it.
The cloth is too dirty or too wet. Clean it or
replace it.
to continue