A DECE OASIS A20F Beast Manual De Instrucciones página 14

Maintenance and Repair
Daily maintenance:
1.The vehicle should be ept clean and clean, and the vehicle should be wiped with dry cloth in time after being
drenched to avoid rusting of parts and short circuit of electrical components.
2.Always chec the air storage capacity of the tire to eep it in normal use.
3.The main transmission parts such as front a le, a roar a le, conter a le, front for , Flywheel and electric hub
should be chec ed and ad usted fre uently to eep the transmission parts e ible without impact sound and
noise Chec the screws and nuts of the bicycle, if it is found that it is loose, it should be tightened in time to
prevent the parts from being worn out or causing greater damage and fracture due to looseness.
Note that the tightening tor ue of front wheel, handlebar core screw rod, saddle pipe clamping Bolt and
saddle clamping Bolt shall not be less than18N.m The tightening tor ue of rear wheel, bottom brac et Cup
and bottom brac et Cup loc nut shall not be less than 30N.m
4.The bra ing part should be chec ed and ad usted fre uently to ma e it in a e ible state, for e ample, the gap
between the bra e rubber and the gate core should not be too large.
5.Always chec whether the operating parts and cable are e ible, and ensure that there is no stagnation, no
stagnation, and properly drip lubricating oil from one end of the hose slowly, and pull the wire rope at the same
time, feel that the wire rope slides lightly in the hose.
6.Electric bicycle moving parts should be often in ected with a small amount of lubricating oil to reduce wear and
eep riding light, as shown in the following table:
Lubrication part
Front a le, center a le, a rear
a le bearing
front fork headset
edal bearing
Chain
Double support locking plate side
support and transmission parts
andle
Name
horizontal tube
18N. m
Running torque
Location Method
Chec whether the bottom brac et Cup is loose/disassemble
Center shaft
the central shaft, wash and change oil, and chec the parts.
Chec the wheel swing, spo e tension, spo es, mother spo e
Front and
rear wheels
for damage Ad ust the wheel
If there is a steel wire at the root of the rolling head,
brake cable
replace the new bra e line.
If there is a steel wire at the root of the rolling head,
brake handle
replace the new bra e line.
Chain
Chec whether the pin shaft is loose or bulging, and
whether the e tension of the chain is too large.
Front and rear nut, handlebar
core screw, saddle clamping screw
Correct use and maintenance methods of motor, controller and battery:
1.The motor should be ept clean, no foreign matter, corrosive li uid, gas, etc. should enter the motor, and the
motor hell should not be noc ed and ba ed to avoid damage to the motor.
2. All wires should avoid friction and contact with sharp metal, and the wires should be tied rmly with the frame.
3.The controller is a high-tech intelligent computer memory program password. If the user opens the repair by
himself, the components will be easily damaged. If the controller fails, please go to the service department to
repair it.
4.This battery is a special battery for electric bicycles.
battery should be stored after su cient electricity, and the electric energy should be replenished regularly to
avoid battery vulcani ation caused by long-term under power.
5.The battery cannot be near open ame or high temperature heat source, and the battery cannot be thrown
into the re. Direct e posure to the sun is strictly prohibited in hot and hot weather.
Lubricant
3 calcium-based lubricating oil
3 calcium-based lubricating oil
3 pieces of calcium-base
lubricating oil
30 mechanical oil
30 and mechanical oil
stem
Saddle Saddle pipe
18N. m 18N. m
Chec for looseness
hen the electric bicycle is not used for a long time, the
i months to one year
alf a year
alf a year
alf a month
alf a month
front a le
18N. m 18N. m
Time
Chec fre uently /once every year
The rst month/year after the
Lubrication cycle
rear a le Center shaft nut
30N. m 30N. m
rst new car
nce every month
nce every three months
nce every si months
nce every si months
12