Descargar Imprimir esta página

Kasanova KIV000040NOC Manual De Instrucciones página 15

Aspiradora inalámbrica de alto rendimiento

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

ANER
HIGH PERFORMANCE CORDLESS VACUUM CLE
15
part of the tube, as shown below (as any other cordless vacuum cleaner) or in
the lower part of the tube. With the motor housing in the lower part of the tube,
the vacuum cleaner is easier to handle, the weight will not strain the wrist and
the arm, plus the power suction is more effective as the air does not pass the
tube throughout its length.
Empty and clean the dust container &dust filter
Note: To get the best performance, empty the dust container and clean the
dust filter after 5 cleanings.
1. Remove the motor housing from the unit. Press down the release button to
remove the motor housing.
2. Push down the dust release button. Empty the dust from the dust container.
3. Press down the release button of dust container to remove the dust
container from the motor housing.
4. Rotate the dust container upper cover towards the "unlock" marking and
take out of the upper lid. Then take out of the dust filter assembly.
5. Take out the upper dust HEPA filter and the plastic cyclone filter. Then wash
them and dry naturally. After dry completely, the put back in the machine. Do
not use a washing machine to clean the dust filter assembly. Do not use a hair
dryer to dry it. Air dry only.
6. Replace the dust filter assembly back into the dust container and push the
dust filter assembly to fix firmly in the dust container. NEVER operate vacuum
cleaner without dust filter assembly in place.
7. Attach the dust container assembly to the handheld vacuum cleaner.
CAUTION: The suction inlet must be open and free of any obstructions at all
times. Otherwise, the motor may be overheat and could be damaged.
Note: it is recommended that the filter should be cleaned or replaced. The
cyclone system should be cleaned every three(3) to six(6) months depending
on usage to ensure best performance of the vacuum cleaner. The power brush
rolling bar should be checked from time to Time, and the hair etc should be
cleaned in time.
In case of wrong operation, such as the power brush rolling bar is blocked by
hair etc, or the main vacuum motor inlet is jammed, or the battery is too hot,
etc, the system may be protected, use the charger to activate it.

Publicidad

loading