Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
Because your product moves a substantial amount of air, it will need
regular cleaning. If service is required, return your unit to Vornado
(see WARRANTY for instructions).
WARNING: To reduce the risk of electrical shock and injury to
persons, unplug the unit before cleaning.
REGULAR CLEANING
1. Unplug unit before cleaning.
2. Use the brush attachment on your household vacuum cleaner to
vacuum any accumulated dust off the unit.
3. Wipe down the entire unit with a soft cloth.
Note: Do not use gasoline, thinners, solvents or other chemicals for
cleaning. The motor is permanently lubricated and requires no oiling.
14 English
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE AND SOLUTION
Unit fails to
Unit is not plugged in. Plug Power Cord into electrical outlet.
power on.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Fuse needs to be replaced. See IMPORTANT INSTRUCTIONS for how to replace the fuse or contact
Consumer Service.
Unit is not producing
Ensure unit is set to highest setting for maximum air circulation.
sufficient amount of air.
Allow the unit to fully circulate the air throughout the room, this may take several minutes.
Ensure all air inlets and outlet grille are unobstructed.
Remote Control is not
The battery is dead. Replace with new 3 volt CR2032 battery. Refer to REMOTE CONTROL - Battery
working.
Replacement for instructions.
The remote requires a line-of-sight path to allow for the signal to be received by the unit. Position the unit
so the receiver lens (located just above the product controls) is visible from the remote control.
Air is not moving in the
Switch the direction of the airflow from DIRECT to EXHAUST (or EXHAUST to DIRECT). If problem
desired direction.
persists, turn unit OFF and ON and adjust settings as needed.
Unit is on but there is no air
Preset temperature in AUTO might be set too high. Lower the set temperature or turn AUTO off.
moving.
15
English
Publicidad
