Ruby S 10-20 G Manual De Instrucciones página 25

INSTRUCTIONS MANUAL
RUBY S 10-20 G
OPERATION INSTRUCTION
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area
matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on a firm level surface, setting the master button to "-" position.plug the cord set into a
AC220-240V electrical outlet,with "BEE" sounds the "Power" light is on.
1 · HEATING PERPARE
Set time
Turn on the heater,set the time as right time.Press remote control button, light on control panel, LED
display shows 00:00 and "Mo" light on.
HOUR Press "Set" button one time,LED display front "00" twinkle, press two buttons set the
Hours from 01--00 (01=1 o'clock, 02=2 o'clock...00=24 o'clock ect.)
MINUTE Press "Set" button again,LED display behind "00" twinkle, press two buttons set the
minutes from 00--59 (01=1 Minute, 02=2 Minute ect.)
WEEK Press "Set" button again,"Mo"light twinkle, press two buttons set the week from Mo--Su
(Mo=Monday...Su=Sunday ect.)
PS: Press "Set" button,screen shows number will twinkle 5 seconds,you should operate in time,
otherwise appliance will get back to standby.
(Appliance will keep the right time until power off)
2 · GENERAL USING OPERATION
1. Turn the heater ON by pressing remote control the ON/OFF button, the unit will blow the cold air.
2. Pressing the "MODE" button on remote control ,the unit will blow the warm air and will light on.
3. Pressing the "MODE" button second times on remote control, the unit will blow the hot air and the
will light on.
4.Pressing the "MODE" button Three times on remote control, the unit will blow the cold air
PS: For smart operate, customer only press the one start button near about master button, the
heater will working with hot air and will light on.
25