Hilti PRA 90 Manual De Instrucciones página 25

Trouble or fault
Setting the monitoring mode
is not successful.
10 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r56543.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
12 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
13 FCC statement (applicable in US) / IC statement (applicable in Canada)
CAUTION
Interference to radio reception Use of the product in residential areas may cause interference to radio
reception.
▶ This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio communications.
▶ However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by taking the following
measures: Re-orient or relocate the receiving antenna. Increase the distance between the equipment
and receiver. Consult the dealer or an experienced TV/radio technician for assistance.
Changes or modifications not expressly approved by Hilti may restrict the user's authorization to operate
the equipment.
This device is in compliance with paragraph 15 of the FCC Regulations RSS­210 of the IC Regulations.
Operation is subject to the following two conditions:
This device shall cause no harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
*2015596*
Possible cause
Excessive vibration from external
influences.
Tripod is out of range.
2015596
Action to be taken
▶ Completely unfold the tripod
and check that it stands firmly.
▶ Approach the tripod more
closely with the remote control
unit and/or align the control
panel towards the remote
control unit.
English 19