Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Serial number:
The serial number is on the product label and on the product carton. Use the
serial number to register your product on www.husqvarna.com.
Support
For support about the product, speak to your Husqvarna servicing dealer.
Symbols on the product
WARNING!: Be careful and use the product correctly.
a
This product can cause serious injury to the operator
or others. Read the operator's manual carefully and
make sure that you understand the instructions before
you use the product.
WARNING!: Risk of crush injuries. Keep hands and
a
feet away from areas where there is a risk of crush
injury.
Note: Other symbols/decals on the product refer to certification requirements
for some markets.
Product liability
As referred to in the product liability laws, we are not liable for damages that
our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from the manufacturer or not
approved by the manufacturer.
• the product has an accessory that is not from the manufacturer or not
approved by the manufacturer.
• the product is not repaired at an approved service center or by an approved
authority.
If the installation is performed by an end customer, the customer assumes all
responsibility.
Safety definitions
Warnings, cautions and notes are used to point out specially important parts
of the manual.
WARNING: Used if there is a risk of injury or death for the operator or
a
bystanders if the instructions in the manual are not obeyed.
CAUTION: Used if there is a risk of damage to the product, other
a
materials or the adjacent area if the instructions in the manual are not
obeyed.
Note: Used to give more information that is necessary in a given situation.
General safety instructions
Under no circumstances may the design of the product be modified without
the permission of the manufacturer. Never use a product that has been
modified in any way from its original specification and always use original
INTRODUCTION
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Husqvarna Automower® Fence Door
2
Product description and intended use
The product is an automated passage door for robotic lawn mowers. The
product lets the robotic lawn mower access areas of the lawn that are
enclosed by a fence. A separate transmitter kit must be installed on the mower
for correct operation.
Note: National regulations can set limit to the operation of the product.
Only use the product with parts and accessories that are approved by the
manufacturer.
accessories. Non-authorized modifications and/or accessories can result in
serious personal injury or the death of the operator or others.
Safety instructions for operation
WARNING: Read the warning instructions that follow before you use
a
the product. If you encounter a situation where you are uncertain how
to proceed you should ask an expert. Contact your dealer or your
service workshop. Avoid all usage which you consider to be beyond
your capability.
• Never use a product that is faulty. Carry out the safety checks, maintenance
and service instructions described in this manual.
• Never allow children or pets to be in the vicinity of the product.
• Use approved eye protection.
• The life span of the product can be reduced and the risk of accidents
can increase if product maintenance is not carried out correctly and if
service and/or repairs are not carried out professionally. If you need further
information please contact your nearest servicing dealer.
WARNING: Never use a product with defective safety components.
a
The product's safety equipment must be inspected and maintained
as described in this section. If your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION: All servicing and repair work on the machine requires
a
special training. This is especially true of the product's safety
equipment. If your machine fails any of the checks described below
you must contact your service agent. When you buy any of our
products we guarantee the availability of professional repairs and
service. If the retailer who sells your machine is not a servicing dealer,
ask for the address of your nearest service agent. Accessories and
changes to the product that are not approved by the manufacturer, can
cause serious injury or death. Do not change the product. Always use
original accessories.
• If the maintenance is not done correctly and regularly, there is an increased
risk of injury and damage to the product.
• Only do the maintenance as this operator's manual recommends. Let an
approved Husqvarna service agent do all other servicing.
• Let an approved Husqvarna service agent do servicing on the product
regularly.
• Replace damaged, worn or broken parts.
Publicidad
