Hisense HBE3501CPSI Instrucciones De Uso página 34

Table continued from last page
Error Description
name
Err 006 Self Clean door
lock failure
Err 007 Failure of power
board relay supply
Err 008 Overheating of
power board
Err 014 Cooktop
activation during
active Self Clean
function
Err 015 Zero cross failure
on power board
EN 34
Possible cause
Door lock on the appliance
is malfunctioning.
Failure of power supply.
Ambient temperature is too
high, NTC sensor is
malfunctioning.
Cooktop was activated while
the Self Clean function was
active.
Failure on electronics.
Solution
Check position of pots. Pots position
might influence temperature on the
user interface.
Stop Self Clean function, wait until the
door is unlocked and start it again. If
the problem persists, contact service.
Check correct voltage in house
installation. Disconnect the cooking
range from the power mains for a few
minutes (undo the fuse or switch off
the main switch); then, reconnect the
cooking range to the power mains. If
the problem persists, contact service.
Check ambient temperature in the
room. Cool down the appliances.
Disconnect the cooking range from the
power mains for a few minutes (undo
the fuse or switch off the main switch);
then, reconnect the cooking range to
the power mains. If the problem
persists, contact service.
Turn off any active cooktop heater and
start Self Clean function again.
Disconnect the cooking range from the
power mains for a few minutes (undo
the fuse or switch off the main switch);
then, reconnect the cooking range to
the power mains. If the problem
persists, contact service.