Publicidad
Idiomas disponibles
Idiomas disponibles
Model 1967
CONNECTING THE REGUL ATOR TO THE
20 LB. LP TANK
Leak test new and exchanged LP tanks BEForE connecting to
griddle. Please reference the Leak Test Instructions section.
S T E P 0 1
LP tank must be properly secured to griddle.
(Please reference the Assembly Guide chapter.)
S T E P 0 2
Turn all control knobs to the OFF position.
S T E P 0 3
Turn LP tank OFF by turning OPD hand wheel clockwise to a
full stop.
S T E P 0 4
Remove protective cap
from LP tank valve.
S T E P 0 5
Hold regulator and
insert nipple into LP tank valve.
S T E P 0 6
Hand-tighten the
coupling nut, holding regulator
in a straight line with LP tank
valve so as not to cross thread
the connection.
S T E P 0 7
Turn the coupling nut clockwise and tighten to a full stop. The
regulator will seal on the back-check feature in the LP tank valve, resulting
in some resistance.
S T E P 0 8
An additional one-half to three-quarters turn is required to
complete the connection. Tighten by hand only – do not use tools.
OPD Hand
wheel
Type 1 outlet with
thread on outside
Relief valve
Strap and cap
Nipple has to
be centered
into the LP
tank valve
Hold coupling
as shown
Fuel | 20 lb. Propane Tank
| Owner's Manual
!
WA r n I n G
Keep the fuel supply
hose away from any
heated surface(s).
!
WA r n I n G
Never attempt to attach
this griddle to the self-con-
tained LP gas system of a
camper trailer, recreational
vehicle or motor home.
Do not use the LP Tank until
it has been leak-tested.
NOTE: If connection cannot be
completed, disconnect regulator and
repeat steps 5 and 6.
If still unable to complete
connection, do not use this
regulator!
NEED HELP?
Register your Blackstone product at
blackstoneproducts.com/register
and visit us online at
blackstoneproducts.com/support
for missing parts, assembly and
operation questions.
15
Publicidad
