Ruby S 10-20 W Manual De Instrucciones página 24

INSTRUCTIONS MANUAL
RUBY S 10-20 W
• Always operate on a flat horizontal surface.
• Switch off the appliance, then use handles (where provided) to change its position.
• Do not operate with the cord coiled up as this could cause a build up of heat, which could pose a
hazard.
• The use of an extension cord with this appliance is not recommended.
• Do not remove the power plug from the socket by pulling the cord – grip the plug instead.
• Always unplug appliance when not in use.
• Do not allow cord to come in contact with heated surfaces during operation.
• Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away from areas where it is
likely to be tripped over.
• Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken
and split. Always ensure that the cord has been fully removed from any cord storage area before use.
• Do not store appliance in a box or closed space until it has cooled down sufficiently.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Young children should be supervised to ensure they do not play with the appliance.
• The appliance must not be located immediately below a socket-outlet.
• Do not use this appliance with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the appliance is covered or positioned incorrectly.
• If the supply cord is damaged, it must be replaced by a qualified electrical person in order to avoid a
hazard.
• Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on the appliance.
• In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
SPECIFICATIONS
Model names Voltage Power
RUBY S 10-20 W AC220-240 V, 50-60 Hz 2000W
24