Ruby S 10-20 W Manual De Instrucciones página 26

Idiomas disponibles

INSTRUCTIONS MANUAL

RUBY S 10-20 W

WEEK Press "Set" button one time,"I/W" lights on, press

two buttons set the week from 1--7

(1=Monday, 2=Tuesday...7=Sunday ect.)

HOUR Press "Set" button again,"II/H" lights on,

two buttons set the Hours from 01--00 (01=1

o'clock, 02=2 o'clock...00=24 o'clock ect.)

MINUTE Press "Set" button again,"Fan/M" lights on,

two buttons set the Minutes from 00--59

(01=1 Minute, 02=2 Minute ect.)

PS: Press "Set" button,screen shows number will twinkle 5 seconds, you should operate in time,

otherwise appliance will get back to standby.

(Appliance will keep the right time until power off).

2 · GENERAL USING OPERATION

1. Turn the heater ON by pressing the ON/OFF main button ,the unit will blow the cold air and "Fan/M"

light is on.

2. Pressing the "MODE" button ,the unit will blow the warm air and both"I/W""Fan/M" lights are on.

3. Pressing the "MODE" button second times,the unit will blow the hot air and both "I/W""Fan/M" lights

are on.

4. Pressing the "MODE" button Three times,the unit will blow the cold air and "Fan/M" light is on.

PS: Control panel and remote control are same operate way.

3 · 24H TIMER FUNCTION

1.Open the appliance as working conditions, (fan, warm, hot are all ok). Control panel "TIMER" button

and remote control

button are same operate way.

2. Press "TIMER" button, set the timer up to 24 hours, keep press "TIMER" button to increase the hours

from 00--24 (00= close, 01=1hour, 02=2 hours... 24=24 hours ect.) and the "TIMER" light is on.

PS: set as "00" means no set timer, the "TIMER" light is off.

4 · THERMOSTAT INSTRUCTIONS

1. Open the appliance as working conditions, (fan, warm, hot are all ok). This function only through by

Remote control.

2. To adjust temperature, press the

to set the desired temperature and the temperature set from

10 °C to 49 °C.

3. When the air temperature drops 2 degree below the set temperature, the heater will start heating with

"I/W"(1000W).

4. When the air temperature drops 4 degree below the set temperature, the heater will start heating

with"II/H"(2000W).

5. When the air temperature high 1 degree or ≤ the set temperature,the heater will blow the cold air.