Publicidad
Idiomas disponibles
Idiomas disponibles
1. One complete tooth not sharp and one damaged
2. Two teeth damaged for 50%
3. One tooth damaged for 100% and one tooth damaged for 50%
EN
4. Two rings damaged for 100%
06
5. Interior ring damaged for 100%
These areas of damage, precisely as wear, are not covered by the warranty. In most cases however
the areas of damage are much less extensive. In doubtful cases an authorised repairer should as-
sess the clamp.
4.
How to operate the clamp
IP(U)10A lifting clamps are suitable for the lifting, turning and vertical transport of steel plates and
structures.
Attention! Do not
See illustrations 3 - 7 for part reference.
put your hands in
the jaw aperture,
1. Open the clamp by pulling the latch lever (A) towards the jaw (3).
the locking cam
2. Pull the latch lever (A) towards the lifting eye (D). The spring (M) is tensioned, but now the clamp
(L) could be
remains open (4).
activated,
3. Lower the clamp on the plate, so that the locking device (L) is activated and the camsegment
causing the
(B) closes. Now the clamp will remain on the plate in pre-tensioned position, allowing lifting to
camsegment (B)
commence (5).
to close.
4. As soon as the load is at its destination let the crane hook descend until the clamp is fully free
of load, meaning that the lifting chain is no longer taut and the lifting eye (D) of the clamp can
move freely. To release the load pull the latch lever (A) towards the jaw, allowing the clamp to
be and remain opened (6).
5. The clamp may now be used again immediately or put away in opened position. This position
will protect the teeth from damage (7).
5.
A reliable clamp, a secure basis for lifting
10 Year warranty preventive maintenance procedure:
During every maintenance service the most critical parts, being pivot(s), camsegment and spring
are replaced and, when necessary, any rejected parts will be replaced.
10 Year warranty repair procedure:
During every repair service the most critical parts, being pivot(s), camsegment, spring, shafts and
latch lever will be replaced and, when necessary, any rejected parts will be replaced.
Please consult www.thecrosbygroup.com/resources/crosbyip-10-year-guarantee for more infor-
mation on maintenance procedures.
Maintenance without 10 year warranty: Annually clamps are subjected to inspection* and parts will
be replaced only when they no longer meet our standards.
* CrosbyIP authorised repairer
Copyright © 2021 The Crosby Group LLC. All Rights Reserved.
Publicidad
