Hilti Nuron SB 6-22 Manual De Instrucciones Original página 15

5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Changing bandsaw blade
WARNING
Risk of injury due to the bandsaw blade. The bandsaw blade might be hot and/or have sharp edges; under
certain circumstances it can break.
▶ Wear protective gloves and eye protection when working and when changing the bandsaw blade.
▶ Use the bandsaw only with the bandsaw blade cover correctly installed.
▶ Never set a bandsaw down on a flammable surface while hot from being used.
ATTENTION
Damage to property due to wrong bandsaw blade. Using a wrong bandsaw blade can lead to premature
material fatigue and damage to the bandsaw.
▶ Select the correct bandsaw blade for the bandsaw and the material.
▶ Select the bandsaw bade with the correct tooth pitch (teeth per inch, tpi) for the material you are going
to cut: higher tpi for hard/thin materials; lower tpi for soft/thick materials.
▶ Use only bandsaw blades that are 0.5 mm thick. Thicker bandsaw blades mean more bending strain and
accelerated wear of the saw teeth.
▶ Select the bandsaw blade such that at least two saw teeth are in contact with the workpiece.
▶ Use only bandsaw blades with the dimensions 1140 mm × 12.5 mm × 0.5 mm.
1. Slacken the screws of both bandsaw blade covers.
2. Remove both bandsaw blade covers.
3. Turn the clamping lever as far as it will go.
▶ The bandsaw blade is loosened.
4. Remove the old bandsaw blade from the guide and disposal of the bandsaw blade.
5. Insert the new bandsaw blade into the bandsaw blade guide.
6. Loop the new bandsaw blade over both pulleys.
7. Insert the new bandsaw blade into the bandsaw blade guide channel.
8. Check that the bandsaw blade is correctly seated.
9. Turn the clamping lever as far as it will go.
▶ The bandsaw blade is tensioned.
10. Install both bandsaw blade covers.
11. Tighten the screws of both bandsaw blade covers.
5.5 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
*2354067*
2
2354067 English 9