Beurer TL 95 Instrucciones De Uso página 19

Idiomas disponibles

Instruction for repairs

IMPORTANT

• Do not open the device. Do not attempt to repair the device yourself. This could result in serious injury.

Failure to comply with this instruction will void the warranty.

• For repairs, please contact Customer Services or an authorised retailer.

4. INCLUDED IN DELIVERY

Check that the exterior of the cardboard delivery packaging is intact and make sure that all contents are

present. Before use, ensure that there is no visible damage to the device or accessories and that all pack-

aging material has been removed. If you have any doubts, do not use the device and contact your retailer

or the specified Customer Services address.

• 1 daylight therapy lamp

• 1 set of instructions for use

• 1 mains adapter

5. DEVICE DESCRIPTION

The corresponding drawings are shown on page 3.

Fluorescent screen

Rear of the device housing

Stand

Mains adapter connector

6. INITIAL USE

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any dam-

age or faults on the device, do not use it and contact Customer Services or your supplier.

Setting up the device

Place the device on a level surface. The position should be chosen to ensure a distance of between 20 cm

and 45 cm between the user and the device. The lamp is most effective at this distance.

Mains connection

• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains

adapter described here.

• Insert the mains adapter into the connector provided for this purpose on the rear of the daylight therapy

lamp. The mains adapter must only be connected to the mains voltage that is specified on the type

plate.

• After using the daylight therapy lamp, unplug the mains adapter from the mains socket first and then

disconnect it from the daylight therapy lamp.

Note

Ensure that there is a mains socket close to the set-up area.

Arrange the mains cable in such a way that no-one will trip over it.

On/Off button

Timer setting

Brightness setting (dimmer)