ETOE A1192 Manual Del Usuario página 3

EN
Safety Instructions
Read and understand all instructions before you use this device.
Do not make any changes or settings that are not described in this manual. Any physical
injury, and loss of data or damage caused by failure of following instructions, is not
included in the warranty.
Setup
To reduce the risk of fire and/or electric shock, do not expose the device to rain or
moisture, and objects filled with liquids, such as vases, should not be placed on the device.
Do not place the device on soft surfaces such as tablecloths or carpets as doing so could
be a fire-hazard.
Do not place the device in areas susceptible to excessive dust and dirt or near any
appliance generating a strong magnetic field.
To prevent overheating, do not block or clog the ventilation openings.
Never place the device in a confined space. Always leave enough space around the
device for ventilation.
Protect the device against direct sunlight, heat, large temperature fluctuations and
moisture.
When the device runs for a long period of time and the surface becomes hot, shut it down
and unplug the power cord. Resume operation only after the device has cooled.
Always handle the device with care. Avoid touching the lens.
Never place heavy or sharp objects on the device or the power cord.
To avoid electric shock, do not disassemble.
Only use attachments or accessories specified by the manufacturer.
Avoid extreme vibration. It may damage the internal components.
Do not allow children to handle the device without supervision.
Under the following conditions, a layer of moisture can appear inside the device which can
lead to malfunctions:
a) if the device is moved from a cold to a warm area;
b) after a cold room is heated;
c) when the device is placed in a damp room.
To avoid any moisture, seal the device in a plastic bag before moving it to another room,
and wait for one to two hours before you take it out of the bag.
Power Supply
Use only the provided power adapter.
Power off the device before removing the power supply from the socket.
Protect the power cord from being walked on or pinched, particularly at plugs,
convenience receptacles, and the point where they exit from this device.
Unplug this device if there are lightning storms or when unused for a long period of time.
Where the power plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
Before you make or change any connections, ensure that all devices are disconnected
from the power outlet.
Never touch the power cable or the power connector with wet hands.
01