ETOE A1192 Manual Del Usuario página 10

ETOE Projector A1192 have two systems, The
[Android TV]
system, So, the projector setting and Android TV setting is
separated, When setting the projector, Press the
back to projector home page, go to
1. Projection setting
Projection mode
[Desktop Front Projection]: The device is located in front of the projection
surface.
[Desktop Rear Projection]: The device is located behind the projection
surface.
[Ceiling Front Projection]: The device is hanging from the ceiling in an
upside-down position. The image is rotated by 180 degrees.
[Ceiling Rear Projection]: The device is hanging from the ceiling in an
upside down position behind the projection surface. The image is rotated by
180 degrees and horizontally mirrored.
Zoom in/out
Use the remote control, zoom in or out from 50%-100%, fit the image size in a
certain screen
Vertical correction
Vertical keystone correction from 0-100
Horizontal correction
Horizontal keystone correction from 0-100
Four point Correction
Use the remote control, [OK] to select the point, 4[Navigation button] to
adjust, [Back] to exit
Keystone correction reset
Reset Keystone correction value
2. Other settings
Default Input Signal
[Android TV]/[HDMI]/ [USB]/[off]
Select default display signal source from Android TV/HDMI/USB, or go to
home page, When turn on or reboot the projector.
No need switch signal source every time when the projector is turned on.
Language setting
Select your language from [English], [Deutsch], [Français], [Italiano], [Español],
[日本語], [한국어].
Restore factory setting
Reset your device and restore factory setting.
Projector Settings
[Setting].
08
[Projector system]
[Projector Home]
and the
Button