Samsung POWERbot SR1AM70 Serie Manual Del Usuario página 34

Information codes
<SR1AM7010U* series>
The three
1
indicators below
blink and an
information
codes alarm
sounds.
Information codes animation
Information codes
Turn off the
2
emergency
switch, check the
instructions below,
and then take
appropriate action.
The POWERbot is caught, stuck or trapped while moving.
Turn off the emergency switch, and then move the POWERbot to
another area.
Foreign matter is caught in the brush.
Turn off the emergency switch, and then remove the foreign matter
from the brush.
Foreign matter is caught in the left Driving wheel.
Turn off the emergency switch, and then remove the foreign matter
from the Driving wheel.
Foreign matter is caught in the right Driving wheel.
Turn off the emergency switch, and then remove the foreign matter
from the Driving wheel.
The bumper sensor needs to be checked.
Turn off the emergency switch, and then turn it back on.
If the information code does not disappear, check if there's any foreign
matter between the bumper and the main body. If there is, pull the
bumper slightly, and then remove the foreign matter.
Foreign matter has accumulated on the obstacle sensor.
Turn off the emergency switch, and then clean the front and rear
sensor with a soft cloth.
Foreign matter has accumulated on the cliff sensor.
Turn off the emergency switch, and then clean the cliff sensor with a
soft cloth.
Main PCB needs to be checked.
Turn off and restart the product. If the same problem occurs repeatedly,
a service check is required.
ENGLISH-34
The information
3
code will
disappear when
you turn on
the emergency
switch
Information codes
Checklist