Franke SMART FSM 709 HI Manual Del Usuario página 14

13. USER MENU
CUSTOMISATION
Before carrying out the procedure, it is advisable to read
the entire paragraph.
– Press .
– Press again and hold
– The key starts flashing.
– Press and hold
dicate .
– Hold and start pressing the digit of the cooking
areas in clockwise order starting from the left front
one.
2
1
The rear left digit alternately indicates
from 2 to 7 indicating the menu code.
The front left digit indicates a number which depends on
the parameters indicated in the selection.
– Press the left rear digit.
– Select a number on the power bar to access the
menu code.
– Press the left front digit.
– Select a number on the power bar to select a value.
See the following table for the specifications:
Menu Description
code
U2 Key sound volume control
menu.
U3 Countdown beeper volume
control menu.
U4 Display brightness level con-
trol menu.
U5 Countdown display control
menu.
U6 Pan detection menu.
U7 Countdown end management
menu.
14
for 3 seconds.
: the digits in the cooking area in-
3
4
and a number
Value
0 - Sound disabled
1 - Min.
3 - Max.
0 - Sound disabled
1 - Min.
3 - Max.
0 - Max.
9 - Min.
0 - Countdown dis-
play disabled
1 - Countdown dis-
play enabled
0 - Enabled
1 - Disabled
0 - Continuous flash-
ing and shut-down
1 - Ten flashes and
shut-down
2 - One flash and
shut-down
– Once the correct value has been entered, confirm by
touching and holding
– To exit the menu without saving, press
If no operation is carried out the user menu will close after
1 minute.
14. POWER MANAGEMENT
FUNCTION
This product has an electronically con-
trolled power management function.
This function controls the delivery of the
maximum power of 3700 W between the
combined cooking areas (left side and
right side), optimising the power distri-
bution and avoiding system overload
situations.
To do this, the total power is monitored
continuously, and reduced when neces-
sary. If it is not possible to supply the
total power required, a control element
reduces by a predefined amount the
power in another cooking element so
that it is at a level immediately below its
respective power curve.This ensures
that the current absorption of 16 A is not
exceeded.
In this case the generator detects the
last command with the highest priority
sent by the user interface and, if neces-
sary, reduces the previous settings ac-
tivated for another cooking element.
The Power management function is first
activated when the presence of a pan is
detected on the cooking element.
Example:
If boost level (P) is selected for hob 1,
hob 2 cannot exceed level 9 at the same
time and will be automatically limited."
for 2 seconds.
.