Vortice Vort HRW 60 Mono Evo HCS Manual De Instrucciones página 34

ENGLISH
The available functions are:
• Auto night
The ambient light sensor detects the presence or absence of ambient light and, depending on whether the
measurement is higher or lower than the threshold (factory set and non-adjustable).
When below the set light level the unit goes to night speed (minimum) and prevents selection of a higher
speed setting.
• Auto HR%
In case of presence of humidity beyond the alarm threshold (60%, 75% or 90% - the default value is
75%), the device automatically selects extraction mode at Boost (maximum) speed.
• Auto comfort
In heat recovery mode, the period that determines the inversion of rotation of the fans is fixed based on
the temperature of the air introduced into the room: if too cold, the cycle time is reduced.
To select a function (fig. 20):
1) press the FUNCTION button for more than 2 seconds.
2) press the SPEED button to select one of the three LEDs
LED1 AUTONIGHT
LED2 AUTO HUMIDITY (HR%)
LED3 AUTO COMFORT
3) press the MODE button to enable the function -> the
chosen LED in the mode column blinks.
4) to SAVE the settings, press the FUNCTION button for
more than 2 seconds.
All SPEED LEDs blink 4 TIMES to indicate correct
storage.
5) to CANCEL and exit the setting procedure, press the
FUNCTION key once. All SPEED LEDs blink ONLY
ONCE WITHOUT SAVING any changes made.
6) to CHECK which function is assigned to the appliance,
press the FUNCTION button for more than 2 seconds:
the LED corresponding to the set function blinks for
about 20 seconds, then all the speed LEDs flash and
the device returns to standard display.
Note: The user can enable all the three functions
simultaneously.
To disable a function (fig. 21):
1) press the FUNCTION button for more than 2 seconds.
2) press the SPEED button to select one of the three
LEDs LED1 AUTONIGHT
LED2 AUTO HUMIDITY (HR%)
LED3 AUTO COMFORT
3) press the MODE button to disable the function.
4) to SAVE the settings, press the FUNCTION button for
more than 2 seconds. All SPEED LEDs blink 4 TIMES
to indicate correct storage.
5) to CANCEL and exit the setting procedure, press the
FUNCTION key once. All SPEED LEDs blink ONLY
ONCE WITHOUT SAVING any changes made.
6) to CHECK which function is assigned to the appliance,
press the FUNCTION button for more than 2 seconds:
: the LED corresponding to the set function blinks for
about 20 seconds, then all the speed LEDs flash and
the device returns to standard display.
34
20
LED
EXTRACTION /AUTO COMFORT
LED
INTAKE /AUTO HR%
LED
RECOVERY /AUTO NIGHT
FUNCTION
BUTTON
1
21
LED
EXTRACTION /AUTO COMFORT
LED
INTAKE /AUTO HR%
LED
RECOVERY/AUTO NIGHT
FUNCTION
BUTTON
1
LED 5
LED 4
LED 3
LED 2
LED 1
MODE SPEED
BUTTON
BUTTON
3 2
LED 5
LED 4
LED 3
LED 2
LED 1
MODE SPEED
BUTTON BUTTON
3 2